im trying to control my LG Monitor with RS232
cant figure out what to put in the software . .
[Link: lgcommercial.com][Link: lgcommercial.com]info:
Baud Rate : 9600buadRate (UART)
Data Length : 8bits
Parity Bit : None
Stop Bit : 1bit
Flow Control : None
Communication Code : ASCII code
Communication Parameter
example:
01. Power On(Command : a)
To control Power On/Off of the Set.
Transmission
[k][a][ ][Set ID][ ][Data][Cr]
Data 0 : Power Off 1 : Power On ff: Read Status L
what the hell do i enter in nevo software for rs232 power on and power off ..