im trying to control my LG Monitor with RS232

cant figure out what to put in the software . .


[Link: lgcommercial.com]

[Link: lgcommercial.com]

info:

Baud Rate : 9600buadRate (UART)
Data Length : 8bits
Parity Bit : None
Stop Bit : 1bit
Flow Control : None
Communication Code : ASCII code
Communication Parameter


example:

01. Power On(Command : a)
To control Power On/Off of the Set.
Transmission
[k][a][ ][Set ID][ ][Data][Cr]
Data 0 : Power Off 1 : Power On ff: Read Status L



what the hell do i enter in nevo software for rs232 power on and power off ..

im typing in
for power on: k a 1 0/r
for power off: k a 1 1/r

am i doing anything wrong?

i connected RS 232 nevo cable from connect port 3 (as i set in the software)
to the rs 232 port of my lg . .

its not reacting to the commands . .
i also tried random different variations . .

Not sure how much different the nevo software is than doing AMX or Crestron, but with them I have used:

for power on: ka 01 010x0D
for power off: ka 01 000x0D

Try not putting spaces between the 'k' and the 'a'. Also , put a zero before the set id number and the '0' or '1' for power, followed by a carriage return (0x0D in hex).

Try this for power off...

ka 1 0\r

Backslash is used for carraige return (\r)

ka should be together.

im a moron . .
i was using forward slash instead of backslash . .
solved all my problems thanks!!

: )

what about two way communication ?
it seams the lg can confirm commands through rs232 . .
does nevo support that?

I have limited experience with Nevo (i made a few buttons for a guy once). I do not know the answer to that question.

lol

thanks . .

Hi,

If you are using NSP 1.1 then you do not need to add the \r.

There is an automatic feature for this. Use the dropdown box in the driver window.



Thanks

D

ahh great tip ill try that thanks!