A couple of days ago I tried using the revert command on the RC5000 (I do all programming offline except I.R. codes and Macros) but it reverted me to the factory default cff. After seeing Ron's post about the developer setting ( [Link: remotecentral.com] - 15th post) I tried setting my config as the default and guess what? It worked!

My question is this: I had 81% free memory, I make a change and revert. It resets to the factory default ccf, not mine. I now have only 50% free (less with the old RC5000 firmware I think!) because the original factory default ccf was bigger right? So, now I've set mine as the factory default what happens to the original and the memory that it occupied.

I'm betting that the original is still there - is there any way to free up this memory?

jamieo