| Post 1 made on September 28, 2012 at 07:22 |
|
Joined: Posts: | September 2012 1 |
|
|
I expect to buy a system consisting of 1-transmitter (2-button) and 2-receivers (1-relay each). Each receiver has a learning button that can be activated in conjunction with the transmitter (or controller). If I use transmitter-1 (the only one) to send a learning code to receiver-1 and then do the same procedure with transmitter-2, will I ensure by pressing button-1 a simultaneous activation of the two receivers which happens to be in 2-different locations? Any comment much appreciated B |
|
| Post 2 made on September 28, 2012 at 13:07 |
|
Joined: Posts: | December 2007 4,149 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
