I have been looking around and can't seem to find them. If anyone has them or can point me in the right direction I would be very thank appreciative.
Thanks,
Kevin

the unit won't respond to one way RS232 codes.  it requires a response from the host.  my understanding is that you send it a command, the unit replies to that command, then you reply back confirming the command.

 you would have to write a 2 way driver to make it work.  what control system are you using?

drop me an email see my profile. I have a sirius tuner model SCH2P operating controlled by a PC with full 2 way communications. I started with the SH1000 but had too many problems so changed to the SCH2P. I have all the docs and manuals needed.

I connect the PC to the Sirius using an FTDI USB to RS232 cable plugged into the 8-Pin DIN connector. I ran a Line from a 12 Volt trigger on my A/V processor to the Sirius so it powers up whenever the A/V Tuner selects the port it (Sirius) is connected to. Works like a charm.

I can provide you with a PC Test program which I used to figure out what was going on.

The major problems I had were a bad antenna unit, but once I replaced it all was OK.

The PC is controlled by both an iPad and a Pronto PRO which also displays where the Sirius is tuned and what is playing (Artist, Album, track). I always put a 24/7 PC in my control loop(s). It is my "Cheap Mans Crestron" and a lot more flexible as I can program it to do anything I want!

Did you ever have the RS232 codes for that SCH2P Sirius System? Stil need some...

As I said in the post prior to yours, . . .

Hi Barry, I have an sch2p sirius radio i would like to control via 232. Could you send me the document that shows the 2way commands? I'd appreciate very much if you could.

I just saw this post. Contact me via email and I will reply to you with what I have.

Hi. Does anyone have the rs-232 documentation?

Also a question - does the rs-232 signal contain the name and artist information for the song playing? Thanks.

I am pretty sure the RS232 protocol for the SCH2P and the SRH2000 are the same.

I have all of it including the programs I wrote to control the SCH2P.

Yes, the rs232 stream has all that information but in a character length restricted reply. Contact me via my email address.