Your Universal Remote Control Center
RemoteCentral.com
RS-232 & IP Control Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 2 made on Wednesday May 23, 2012 at 17:38
Duct Tape
Loyal Member
Joined:
Posts:
November 2008
5,302
the unit won't respond to one way RS232 codes.  it requires a response from the host.  my understanding is that you send it a command, the unit replies to that command, then you reply back confirming the command.

 you would have to write a 2 way driver to make it work.  what control system are you using?
[Link: facebook.com]


Hosting Services by ipHouse