| Post 1 made on Thursday December 1, 2011 at 21:01 |
mdlt Long Time Member |
Joined:
Posts: | October 2010
21 |
|
|
Hi Everyone,
I am controlling an NEC TV with RS232 connection, but no matter what command I send, it keeps replying: \x00 1 NG 2x \x0D \x0A
I'm gussing this some sort of error message, does anyone know what this means and what I should do about it?
I noticed that PC Control is grayed out in the TV menus, I wonder if this has anything to do with it?
Cheers
|
|
| Post 2 made on Wednesday December 7, 2022 at 05:16 |
Masmay Junior Member |
Joined:
Posts: | December 2022
1 |
|
|
Hello
I am trying to use on/off switch on my nec tv remote control on my mobil.
I have followed documents on this subject very carefully without any success
Using esp8266 ir remote example in Arduino ide ,I have included the decimal equivalent of hex number obtained from on/off switch on the remote using IRrecvDumpV2 example in ide. To make sure I have the correct hex number I used the ones that repeated several times in a dark area.
Then I get the IP address from serial monitor and in a browser I get the on/off switch
Then in two different assembly with two nodemcu, using my browser I send the signal through ir diode to ir receiver and I get different hex no from the one I used in IRServerr example initially.
Pls give a hint to solve the problem
|
hobbyist, |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
