Post 2 made on Wednesday December 7, 2022 at 05:16 |
Masmay Junior Member |
Joined: Posts: | December 2022 1 |
|
|
Hello I am trying to use on/off switch on my nec tv remote control on my mobil. I have followed documents on this subject very carefully without any success Using esp8266 ir remote example in Arduino ide ,I have included the decimal equivalent of hex number obtained from on/off switch on the remote using IRrecvDumpV2 example in ide. To make sure I have the correct hex number I used the ones that repeated several times in a dark area. Then I get the IP address from serial monitor and in a browser I get the on/off switch Then in two different assembly with two nodemcu, using my browser I send the signal through ir diode to ir receiver and I get different hex no from the one I used in IRServerr example initially. Pls give a hint to solve the problem
|
|
hobbyist, |
|