| Post 1 made on Tuesday May 8, 2007 at 08:57 |
simoneales Select Member |
Joined:
Posts: | May 2005
1,782 |
|
|
Hi All,
I have programmed around 200 Marantz RC5400 remotes now. Far and away the most common problem i have encountered is the "cursor navigation" turning itself on out of the blue. It often happens months after the programming is done. The distributor says that it will be a problem with with a device file that i commonly use. Does this sound reasonable or does anyone else who programmes lots of these have the same issue?
Any feedback would be welcome.
Cheers
Simon.
|
I guarantee I'll tell you the truth and I guarantee I'll tell you what you need to know but I can't guarantee that I'll be telling you anything you want to hear. |
|
| Post 2 made on Tuesday May 8, 2007 at 19:13 |
Lyndel McGee RC Moderator |
Joined:
Posts: | August 2001
12,933 |
|
|
More than likely, you have a hard button with a special action 'Cursor Navigation' somewhere in your config. Or, the user is simply reflashing firmware, in which case, Cursor Nav will return to 'On' state.
|
Lyndel McGee
Philips Pronto Addict/Beta Tester
|
|
| OP | Post 3 made on Friday May 11, 2007 at 03:51 |
simoneales Select Member |
Joined:
Posts: | May 2005
1,782 |
|
|
Thanks Lyndel,
I'll double check for that.
Cheers
Simon.
|
I guarantee I'll tell you the truth and I guarantee I'll tell you what you need to know but I can't guarantee that I'll be telling you anything you want to hear. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
