Post 1 made on Sunday February 10, 2008 at 05:31 |
Theinstaller Long Time Member |
|
|
Hi All, can somebody shed some light on this : I have just received my first Nevo Q50, so I loaded the software on my Vista laptop (all went well), updated software (all went well) plugged in the USB cable to my fully charged Q50, (all seemed to be going well) windows mobile pop-up appears on top of Nevo Studio Pro, the MAC Address of the Q50 gets breifly displayed at the bottom right hand side of Nevo Studio Pro then displays "Nevo Not Connected" and the Windows Mobile pop-up stays displayed on the laptop screen displaying "please wait while Windows Mobile Device Center Starts" this display stays forever unless I "Control Alt Del"
Regards
The Installer
|
Theinstaller |
|
Post 2 made on Wednesday February 13, 2008 at 13:46 |
remoteshoppe Long Time Member |
Joined: Posts: | March 2005 484 |
|
|
I'm using WinXP with Active Sync so it's a completely different experience but I found that if the Q50 goes to sleep too quickly when connected to my laptopn it will cause active sync to lock up like you describe. You may want to make sure the Q50 is staying awake.
|
|
|
OP | Post 3 made on Tuesday February 19, 2008 at 18:21 |
Theinstaller Long Time Member |
|
|
Thanks for your reply, I have experienced this when it does decide to connect but not all the time, at times it connects everytime, but the last time I had to remove the sync association between the Q50 and my Vista laptop!
|
Theinstaller |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.