| Post 1 made on Saturday December 4, 2010 at 15:49 |
I have a Golden Blount gas fireplace. It has a remote but does not use IR I believe its a RF. I have a NC-50. How can I make this work?
Thanks for any input.
|
|
| Post 2 made on Saturday December 4, 2010 at 15:55 |
Duct Tape Loyal Member |
Joined:
Posts: | November 2008
5,299 |
|
|
you wont be able to control it via RF. you may be able to get some type of IR controlled relay, and use that to act like a wall switch. i suppose you could even use an ir controlled relay, and solder to the contacts of the fireplace rf remote, simulating a button press on the rf remote.
before you get into too much of a science project though, i would contact the fireplace manufacturer and see if there are other control options. maybe you can get a part that will add ir control.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
