Post 1 made on Saturday September 24, 2022 at 18:16 |
I have a client with a Pro24.r with a ProLink.r that has been in place for a number of years – the current programing includes Dish Network Sat receiver commands – the owner is changing to a Directv model HR54-500 Sat receiver – I have not worked with ProControl in the last few years – I seem to remember being able to easily replace a “similar” device IR code set in the software without having to pull all of the IR codes in “one at a time” – Am I day dreaming??
|
|
Post 2 made on Saturday September 24, 2022 at 18:47 |
Trunk-Slammer -Supreme Loyal Member |
Joined: Posts: | November 2003 7,462 |
|
|
I believe you would need to drag and drop each individual codes that you want.
If you try moving the codes en masse, the program puts them where the program wants them, not where they need to be.
|
|
OP | Post 3 made on Saturday September 24, 2022 at 19:06 |
|
Post 4 made on Sunday September 25, 2022 at 09:46 |
MNTommyBoy Senior Member |
Joined: Posts: | November 2010 1,063 |
|
|
As long as you still have the original programming file, you can just add the DirecTV device and change your macro to go to the new page. All the basic commands should show up automagically on the DTV page.
If you do not have the original file, then you have to do it from scratch. You cannot pull files from a PC remote (like you could an RTI).
|
"There's a big difference between winging it and seeing what happens. Now let's see what happens." ~MacGruber |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.