Post 1 made on Tuesday February 13, 2024 at 21:00 |
A911Pro Junior Member |
Joined: Posts: | February 2024 5 |
|
|
Probably a stupid question but I'm relativity new at Crestron programming.
On an Adagio AMS running a 24 room demo program with support for the TPMC-8X-GA Touchpanel, plus others, do the touch panels get there configuration, screens, Etc from the AMS when properly connected and listed in the IP Tables or do the screens have to be separately configured and loaded via simpl?
Can't fo the life of me find an answer to this question.
Thanks, Don
|
|
Post 2 made on Friday February 16, 2024 at 16:08 |
johnmax Long Time Member |
Joined: Posts: | June 2004 189 |
|
|
If youre using Simpl then yes you need to build all the interfaces in VTPro. If you were using the old Adagio Composer software then its all built "automatically" in that. But why on earth are you even using that dinosaur stuff? You could get a 3 series processor and an older TSW panel on Ebay for a few hundred bucks if you really want to learn Simpl.
|
|
OP | Post 3 made on Monday February 19, 2024 at 14:33 |
A911Pro Junior Member |
Joined: Posts: | February 2024 5 |
|
|
Jonmax,
Thanks so much for your reply and info. I'm using the AMS because it was affordable and seems to work well for my needs other than theater mode which I was trying to get a touch panel working for. It says it supports the TPMC-8X panel but couldn't figure out how to load it. Is Adagio Composer still around, if so I could possibly get it working with that. I'm still working with SIMPL and VTPro but at 76 this stuff is a bit hard for me to learn, but I haven't given up yet. Don
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.