| Post 1 made on June 24, 2020 at 02:51 |
karbotilne5 Lurking Member |
|
|
As the title implies I've been fortunate enough to inherit a DM switcher. I have never programmed Crestron but do have an unfortunate amount of experience with AMX :). I'm currently evaluating Kramer Control and would like to know if anyone has had success controlling a DM with a "3rd Party"? Ive seen examples of protocol like SETAVROUTE SETVIDEOROUTE SETAUDIOROUTE etc.... But what is the procedure and syntax for sending this? Simpy sending the command to the IP and a specific port via TCP/UDP? or HTTP?https://1921681254.mx/ Any advice is appreciated, even "you're a dummy for trying this!" https://100001.onl/
Last edited by karbotilne5 on June 24, 2020 03:36. |
|
| Post 2 made on June 26, 2020 at 09:43 |
SWOInstaller Select Member |
Joined: Posts: RC XP: | October 2010 1,620 157⭐︎ |
|
|
Haven't tried it personally but you should be able to SSH/Telnet into it and send commands that way (providing the previous installer didn't disable these ports).
|
You can't fix stupid |
|
| Post 3 made on June 26, 2020 at 12:26 |
|
Joined: Posts: RC XP: | October 2002 2,597 178⭐︎ |
|
|
I know people who have controlled it with Savant. Not familiar with Kramer having a control system.
|
CEDIA University Designer CAT Team Member
CEDIA University Instructor
CEDIA Registered Outreach Instructor |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
