Post 1 made on Saturday May 5, 2018 at 02:57 |
I have a dmps-300-c processor and I am trying to use the Ir input to receive commands from a RC5 remote. I am just using a cheap Ir receiver that I am sure is connected correctly ( tip-signal, ring-+5v and sleeve is ground ) I am fairly new to simpl but this is what I have done so far: I have assigned the rc5/universal remote driver to the C2l-DMPS-IR-INPUT slot 5 According to instruction all I have to do is compile/send then go to toolbox/system info/functions/identify transmitter and I should see the Ir codes transmitted by the remote, but nothing.. I have tried all sorts of options but I am slowly going crazy. Any help would be very much appreciated. Kind regards
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.