On April 14, 2008 at 00:43, wentufy said...
I am currently using MX-3000 with MRF-350 base station
for my family room, Mx-850 with MRF-350 for my master
bedroom and MX-850 with MRF-350 for my dining.
Since i am using the same model of TVs at all locations,
so i have set all the MRF-350s with different IDs and
I even assigned the IR port with only RF signal sending
out.
However, whenever someone in Dining Room/master bedroom
controlling the TV and at the same time, i control the
TV at family room, the signal from Dining Room/master
bedroom would interference my control at family, i.e.
the TV at family will respond to the signal from Dining
Room/master bedroom... It reli annoys me so much.
All the MRF-350s have its own ID with the IR emitter port
assigned, with IR blaster "off".. anyone has any ideas
why this happen? All the MRF-350s are put together in
the same location, next to each other.. does it matter?
The MRF-350 will receive all commands sent by any MX-3000 in your house.
Only the right commands containing the right ID will be let through.
If 2 person's presses a command at the same time can cause problems, only 1 at the time can be read.
Maybe the command from the person in your dinning room will be received and read, your might have been let aside.
I had this problem before and this is how I understood it.
Correct me if i'm wrong.