Post 8 made on Thursday December 17, 2009 at 03:01 |
sydinstaller Active Member |
Joined: Posts: | February 2004 740 |
|
|
Hi,
You said that you left the IR info alone!
NSP does not configure anything to the NC-50. All you items will appear in the NC-50 config page but YOU need to click what port the codes come out from.
Also. If NSP did not enable the z-wave you may need to manually tick "enable z-wave" in the settings section of NSP (the two little gears near the d/l button)
D.
|
|
|