Post 4 made on Tuesday December 15, 2009 at 00:08 |
Tazdev Lurking Member |
Joined: Posts: | November 2009 5 |
|
|
I was sick and out for a while. I went to add the NC-50 and I think I may have missed something. I added the NC-50 to the Nevo Ecosystem. It asked me about the MAC and checked the Firmware as you noted it would. I left the IR information alone since it is already configured for the devices. I then saved the config. I disconnected the NC-50 and connected the Q50. Downloaded the new config to it and then "rebooted" it. No wizard came up. What did I miss? It never prompted me to configure the Z-Wave network.
|
|
|