|
|
|
Audio, Receivers & Speakers Forum - View Post
|
|
|
|
|
The following page was printed from RemoteCentral.com:
Post 42 made on Sunday April 24, 2005 at 20:05 |
problemssuk Lurking Member |
|
|
My taps turned into slaps, then into bangs, then into a cracked front plastic bezel on my vr 507 receiver to get it to work. After doing the fix I left the bezel off and took of the clips that attach it. I have the bezel sitting its position. I might reorder the plastc bezel and will only have to pop it back on.
When you said solder the three 'joints', I assumed you meant individually and not solder them together. It's hard to tell in your picture. So far it seems ok. Taking it apart isn't that easy. I had to tape the 'electrical ribbon' to the board because it kept slipping out of its connector. It slipped out after I did the fix and put the cover back together.. Those fools need to make those electrical ribbons longer.
So far, so good and thanks for posting this fix!!!!!!!!
This message was edited by problemssuk on 04/24/05 22:47 ET.
|
|
|
|
|
|
|