Your Universal Remote Control Center
UEI Nevo Remote Controls Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 12 made on Thursday November 17, 2011 at 18:45
Duct Tape
Loyal Member
November 2008
 if the nevoconnect was new in box when you received it, it will have to have a firmware update in order to work.  (assuming you are using Nevostudio 3.0)

so you are going to have to get the usb connected either way.

the nevoconnect manual explains how to do a factory reset.   It has been awhile, but I believe you have to hold in the reset for about 10 seconds.

Hosting Services by ipHouse