Your Universal Remote Control Center
RS-232 & IP Control Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


Xantech IPRS23202 and Sooloos
This thread has no replies.
Post 1 made on Friday February 27, 2009 at 07:57
Active Member
February 2004

Hi have a Sooloos system. I can talk to it using HyperTerminal¨¨ over IP.

I would like to use a Nevo to control the Sooloos using RS-232. So this is where the Xantech comes in.

I have got the IPRS232 working between 2 computers one using IP the other RS232. This bit is all good.

What I canít work out is how to make the Xantech talk/listen to the Sooloos.

Here is an example setup.

The Xantech is set to
The Sooloos is set to port 9011
The Remote/PC is connected to the Xantech via RS232.

Can any one help? The Xantech manual leaves a lot to be desired and tech support has not got back to me.



Last edited by sydinstaller on February 28, 2009 16:28.

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse