Post 1 made on Friday September 25, 2009 at 12:24 |
select Founding Member |
Joined: Posts: | January 2002 229 |
|
|
Anyone else lose the ability to select which port to send either IR or RS232 commands to form the Library Browser drop down. Also no driver drop down. It is as if the file does not contain a processor.
|
|
Post 2 made on Friday September 25, 2009 at 12:48 |
RTrain Long Time Member |
Joined: Posts: | December 2007 108 |
|
|
check your output under properties
|
|
OP | Post 3 made on Friday September 25, 2009 at 13:14 |
select Founding Member |
Joined: Posts: | January 2002 229 |
|
|
Output is two way trigger codes. I know its a problem because every file does the same the, no drop down.
|
|
Post 4 made on Friday September 25, 2009 at 18:16 |
doglife Long Time Member |
Joined: Posts: | December 2002 54 |
|
|
I have the same issue, no drivers under library browser driver tab. I just asked Clint today (training) about it. He said that there were funky issues like that in older versions of ID but not new version 7. This has happened twice. I had to back up and delete ID and re-install. I will do this again tonight.
|
Technology pushes technology, not people |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.