Post 1 made on Wednesday April 17, 2013 at 10:58 |
BlackNGold Lurking Member |
Joined: Posts: | January 2005 6 |
|
|
Hi all. I just recently purchased a new TV, and I'm trying to change the code for the TV so I can control it.
Following the instructions in the manual, I try:
1) COMMANDER OFF + MUTING 2) PRESET 3) Press TV and the remote beeps twice and 'NG' flashes on the screen
I get the same reaction when I press STB (which I have setup to control my DirecTV STB, but if I press AMP (which is already set to control my Pioneer receiver), the problem does not occur and I can get to the next step which is to enter the component code.
Can someone help me determine what I need to do to reset the component code for the TV button?
Thanks Travis
|
|
OP | Post 2 made on Wednesday April 17, 2013 at 13:18 |
BlackNGold Lurking Member |
Joined: Posts: | January 2005 6 |
|
|
Just found a thread from 2003 that might be the issue.
If you have any LEARNED commands for the component, you must delete this first before you can reset the component code.
I know that I programmed learned commands for the TV and STB, so it makes sense that those two I cannot reset, but the AMP/AV Receiver can be reset.
Hopefully this is it. I will try it out when I return home.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.