In the review it states that "Sony has added four spaces to the bottom of the screen, each of which can hold an 8-character customized text label. Each device gets three pages of these - with over 18 devices that's a total of 216 custom labels."

I have followed the instructions to change labels on page 1 I guess. The first four.. How do you get to the other pages for a total of 12 per device... I can't seem to find it in the manual or on this site..
Thanks for any help...
Dan

You access the 2nd and 3d row by pressing the device name at the top right hand corner of the screen, next to the power button.

Don’t feel bad that you couldn’t find this in the manual. After much searching, I finally found it on page 6, paragraph 4, where is gave these cryptic instructions:

The selected modes (up to 8 characters in each label key) are displayed. Labels change in the order from the first stage to the third stage and come back to the first and so on each time you press the mode display key.

RM-AV3000/3100 NEWCOMER’S PACKAGE-WELCOME-CHECK THESE OUT (IF YOU HAVEN’T ALREADY DONE SO) AND SAVE YOURSELF SOME PROBLEMS

AVOID SYSTEM CONTROL PROBLEMS

HOW TO LABEL, CHANGE OR HIDE BUTTONS

CHANGING BATTERIES (May not apply to RM-AV3100-time will tell)

AND IF YOU HAVE A SONY RECEIVER:
CHANGING YOUR RECEIVER AND REMOTE TO AV1 (or AV2) COMMAND MODE


This message was edited by Ron Aronson on 07/30/04 08:54.

Great thanks... I knew it was the driver that was at fault... Just conuldn't figure it out...

Actually you did a good thing, because I didn't realize I didn't have this info in my How To Label, Change, or Hide Buttons thread, and it is nowhere to be found except for that obscure reference in the manual, as far as I can tell.

I have updated that thread to include this info twice, once as a general statement for component screens, and again under the labelling process for components, system, or timer label buttons..