Post 1 made on Tuesday October 4, 2005 at 18:25 |
puckster02 Lurking Member |
Joined: Posts: | October 2005 3 |
|
|
I have an Onkyo TX-DS777 Receiver which has a "On" and separate "Standby" function to turn the receiver on or off. I cannot seem to program or "learn" either of these functions on the existing power button under the amp setting. Any ideas?
And on a related issue, since the Sony remote only has one "power" button, how do I handle the separate on and off commands that my remote and receiver seems to use?
|
|
Post 2 made on Tuesday October 4, 2005 at 23:00 |
cb1 Select Member |
Joined: Posts: | September 2002 1,663 |
|
|
On the amp page relable two places to say "amp on" and "amp off" then teach those commands from your amp remote to those buttons. After that just use those commands in you macro's. cb1
|
why have a nice system if you cant operate it, program the remote the right way the FIRST time! |
|
OP | Post 3 made on Wednesday October 5, 2005 at 02:21 |
puckster02 Lurking Member |
Joined: Posts: | October 2005 3 |
|
|
Thanks for the reply cb1. That takes care of the "second" issue. For some reason however, following the directions, step by step, the Sony remote fails to "learn" the Onkyo's on or off command.
|
|
Post 4 made on Wednesday October 5, 2005 at 03:19 |
edmund Elite Member |
Joined: Posts: | April 2002 13,841 |
|
|
If it was a bad learn, you can't reteach until you clear the key.
|
|
OP | Post 5 made on Wednesday October 5, 2005 at 03:39 |
puckster02 Lurking Member |
Joined: Posts: | October 2005 3 |
|
|
Thanks edmund - I think I have figured everything out now..
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.