| Post 1 made on Wednesday September 28, 2005 at 18:29 |
christofer Lurking Member |
Joined:
Posts: | September 2005
1 |
|
|
hi all
i have a problem with my sony 3000 remote. everytime i programme a power off function, it seems to give an extended blink which will turn off my sony amp and then back on within a second or so. am i doing anything wrong? has any one else experienced this problem or have a fix for it??? please help....
|
|
| Post 2 made on Thursday September 29, 2005 at 09:46 |
Ron Aronson Super Member |
Joined:
Posts: | June 2002
3,967 |
|
|
If you are learning the function, be sure and hold the key on the original remote down until the 3000 beeps. If you are programming one of the system control buttons, check out the following link. SYSTEM CONTROL KEYS: Everything you need to know about them If this doesn't help, please list the exact procedure you are using to program the power off function, including all commands.
|
|
| Post 3 made on Monday October 31, 2005 at 19:07 |
rmhamil Lurking Member |
Joined:
Posts: | October 2005
4 |
|
|
My TP501E commands the E9000ES into standby mode as it should and pressing any function key wakes it up, as it should. However, I have been unsuccesful learning this full command into my AV2100.
If the 9000 is on, the AV2100 will put it in standby from the learned command but I have been unsuccesful getting the 9000 out of stnadby mode using the AV2100. No doubt there is a simple solution but being a neophyte at all this I have not been able to break the code.
Any help would be appreciated.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
