Post 1 made on Thursday July 8, 2004 at 17:59 |
livncelebration Lurking Member |
|
|
Can't seem to figure out how to learn commands to the Channel +/- buttons on my AV2100. Help please!
|
|
Post 2 made on Thursday July 8, 2004 at 19:09 |
Ron Aronson Super Member |
Joined: Posts: | June 2002 3,967 |
|
|
You learn on the Ch +/- buttons the same way as on any other button: Commander off/TV Press Ch + or - button (if learn doesn't flash, and Ch + or - doesn't show under the flashing Learn signal, then you have already learned something on that button and need to clear it by pressing Reset and the key at the same time) Press key on teaching remote The 2100 should beep and the signal has been learned.
|
|
OP | Post 3 made on Thursday July 8, 2004 at 20:02 |
livncelebration Lurking Member |
|
|
Hey thanks a lot, I was forgetting what I needed to hold down along with Commander Off to get into learn mode. Thanks again!
|
|
Post 4 made on Thursday July 8, 2004 at 23:28 |
Ron Aronson Super Member |
Joined: Posts: | June 2002 3,967 |
|
|
If you need the manual, click here, then click on Get File and then click on Save [Link: remotecentral.com]
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.