Post 1 made on Friday May 17, 2002 at 16:06 |
I have a Sony SAT-B50 receiver and a RCA DWD490RE UltimateTV/DSS receiver and some of the Sony remote functions (like calling up Guide, changing channels, etc.) activate the RCA as well. Is there any way to correct these conflicts? I use one IR system throughout my house so that I can control and then view either receiver on any tv in the house so merely having them in different rooms will not help. I need to have the IR addresses be completely different. Any suggestions?
Thanks,
Steve
|
|
Post 2 made on Friday May 17, 2002 at 16:09 |
John Pechulis Loyal Member |
Joined: Posts: | July 2001 7,127 |
|
|
Can you change the remote address on the Sony receiver?
JJP
|
|
OP | Post 3 made on Friday May 17, 2002 at 16:53 |
Well, that was my hope. But I'm not sure how to check if I can do that. Would there be a button or switch on the receiver itself that would do that?
|
|
Post 4 made on Friday May 17, 2002 at 22:30 |
edmund Elite Member |
Joined: Posts: | April 2002 13,841 |
|
|
smgran my utv useto respond to the sony remote also. but after the recent upgrade it doesn't do it anymore.it still responds to the dishnet code.have you tried it recently? the B50 can't change addresses.
|
|
OP | Post 5 made on Saturday May 18, 2002 at 00:11 |
WOW! You're right! That is so great. Thank you so much. I hadn't tried it since the upgrade and had them in different rooms, however with our new house we have wiring that I wanted to have them broadcast throughout the dual coax I have in each room and use the pre installed ir system that I also had.
This eliminates a major headache. Thanks again.
Steve
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.