Post 1 made on Thursday August 12, 1999 at 16:21 |
Jerry Bank Historic Forum Post |
|
|
Reading about the Cinema 6 I rushed to my Wal-Mart and purchased one. It is a remarkable bargain. A few problems seem to exist.
When I set it up for my JVC receiver (only one setup code available), it talked to it, but the numeric keys did not function in any sort of predictable way. Any ideas? I emailed UE, but so far have not received a response. (I will try the learning technique mentioned in another thread to remap the number keys).
I also cannot set it up to operate a Marantz receiver. I guess that I could try to program all of the keys for that item. Of course by doing so much "learning" I may very well run out of memory.
I would appreciate any advice.
|
|
OP | Post 2 made on Thursday August 12, 1999 at 16:23 |
Jerry Bank Historic Forum Post |
|
|
I forgot to mention that the Marantz is quite controlable with a UE URC-4050, so it shouldn't prove to be an impossible task.
|
|
OP | Post 3 made on Thursday August 12, 1999 at 17:58 |
Jerry Bank Historic Forum Post |
|
|
I reprogrammed the number keys for my JVC receiver and it worked just fine. I then tried to program all the codes for my Marantz, and it was unable to accept them.
Does anyone know how many codes can be stored?
|
|
OP | Post 4 made on Thursday August 12, 1999 at 20:57 |
Daniel Tonks Historic Forum Post |
|
|
I've heard somewhere around 20 or so, but that of course depends on how long the stored IR codes are. Some are incredibly long, others are insanely short.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.