Post 1 made on Sunday February 5, 2006 at 16:49 |
Nir Long Time Member |
Joined: Posts: | August 2005 11 |
|
|
Hi I have philips pronto NG and very often it get freez when i send an IRE command i alredy update me frimware to 3.8.14 and it still get freez from time to time can you help me to solve this problem .
thanks from advance .
|
Nirdan |
|
Post 2 made on Monday February 6, 2006 at 11:52 |
Lyndel McGee RC Moderator |
Joined: Posts: | August 2001 13,007 |
|
|
If the unit always locks in the same place, check the IR codes that you are sending and ensure that they are Clean. See the pronto/pronto NG FAQ for a discussion of clean codes.
You might also try backing off your Firmware to 3.7.7 or 3.8.11 and see if the problem goes away.
There is what has been reported to be a page jump slowdown (perceived memory leak) with the 3.8.14 firmware. A simple reset about once every 2 weeks may avoid your problem for now.
If all else fails...
You should email your PCF to ProntoTeam at Philips dot com. In the subject line, please indicate that this is a problematic PCF that causes a freeze from time to time.
If you have an exact set of steps/method to reproduce the problem, you will definitely help the engineers.
|
Lyndel McGee Philips Pronto Addict/Beta Tester
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.