Post 1 made on Sunday May 1, 2022 at 07:16 |
I'm trying to set up a Harmony Elite to operate a Cisco DVR. Everything works fine, except it does not turn on and off correctly. The "Power On" and "Power Off" commands don't do anything, only "Power Toggle". How can I fix it? I would prefer to use the on and off commands, but I can't even figure out how to change both to toggle!
|
|
Post 2 made on Friday May 6, 2022 at 20:36 |
Daniel Tonks Wrangler of Remotes |
Joined: Posts: | October 1998 28,780 |
|
|
Sadly, last time I checked Cisco steadfastly refused to add discrete power commands. You can check the setup menu to see if there are any power on options that might allow you to turn it on by pressing a number key, for example.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.