| Post 16 made on Monday August 30, 2004 at 14:26 |
DWost Long Time Member |
Joined:
Posts: | August 2004
17 |
|
|
Hey Jon-
Sorry for the delay as I'm traveling this week for work. As I'm sure you know, I actually posted that over at AVS as well. I tried the two descretes for on/off that you posted on 8/28 and they did not work. I'll give the codes you just posted a shot when I get home later this week. Thanks again for all the time you've devoted to helping me as well as all the other Z1/Z2 owners out!!
Regards,
Don
|
|
| Post 17 made on Monday January 31, 2005 at 13:05 |
DWost Long Time Member |
Joined:
Posts: | August 2004
17 |
|
|
Jon, Long time no chat!! Well, everything was working fine as the final codes you posted over on AVS did work. That was until I added the RFX6000 RF converter into the mix. I had to add an IR blaster to the front of my room in order to control the PJ with the RF interface. I have it hardwired into one of the 4 ports on the RFX6000. I think by adding a hard wired IR control, there is now some additional latency that occurs and then codes don't work. Again, If I hold down the button I get it to work, however, it is not working in my power on/off macros. Any additional ideas on adding some sort of a delay into the code to get the PJ to recognize it???? TIA
Don
|
|
| Post 18 made on Friday March 25, 2005 at 08:16 |
DWost Long Time Member |
Joined:
Posts: | August 2004
17 |
|
|
HI gang, been off for awhile and wanted to see if anyone had input on my power on/off issue?? TIA
|
|
| Post 19 made on Tuesday September 6, 2005 at 20:22 |
maxwellhaus Lurking Member |
Joined:
Posts: | September 2005
2 |
|
|
Have you seen codes for the Sanyo PLV-70
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
