Hi,

I know there are a couple of posts regarding the Aquavision TV's, but none of the codes I tried where actually able to switch the screen off. I have two Pro range screens and got the IR/RS232 codes set from Aquavision. I only need to switch the screen on/off as it will always remain on HDMI 1. Below are the two lines for the commands I require. Maybe somebody knows what these codes mean and could help me out with the Pronto CCF codes?

POWER ON
Key no: 41
IR Code: 03FCH26

POWER OFF
Key no: 42
IR Code: 03FCH27

General IR information at the bottom of the document:
PARAMETER 0 = TYPICAL 1.12MS, RANGE 1.0-1.23MS
PARAMETER 1 = TYPICAL 2.25MS, RANGE 2.0-2.4MS
PARAMETER LEADER = TYPICAL 9.0MS, RANGE 8.0-10.0MS
WORD DISTANCE 108MS


Any advice or help would be greatly appreciated!!

This thread has additional Aquavision codes of the same form.  Based on John Fine's reply in that thread, I assume that all of these IR signals are NEC protocol (I can't tell for sure whether NEC1 or NEC2)  device 3.

Protocol=NEC1

Great! Thanks!

I'll give them a try tomorrow. May I ask how or what tool you used to get the CCF for these NEC codes?

They work perfectly on the one screen, but only the POWER ON works on the other. I've mailed AquaVision a couple of times already again with no response...:(

PS: I did swap the screens to make sure it is not a control system problem.

Thanks for the help!!