Hello experts,

I try to control my RGB LED tape mounted on the ceeling in the living room using my Pronto 9400.

I have learned the codes from the original remote, but with the learned codes sometimes it works, most of the times not.
Also when learning the lenght of the codes is not consistant.

Therefore I believe that the original remote is not sending out clean codes.

Below you find the example for power toggle:

0000 006C 0022 0000 0157 00AC 0015 0015 0016 0015 0016 0015 0015 0015 0016 0015 0016 0015 0015 0015 0016 0015 0016 0040 0016 0040 0015 0040 0016 0040 0016 0040 0015 0040 0016 0040 0016 0040 0015 0015 0016 0015 0016 0015 0015 0015 0016 0015 0016 0015 0015 0040 0016 0015 0015 0040 0016 0040 0016 0040 0015 0040 0016 0040 0016 0040 0015 0015 0016 0040 0015 C94E


Is that lenght OK or what is the clean code for power toggle here?

Thanks ind advance,

miwi

Try this,

Thank you Jasonvp

the code works perfect.

Is there a chance to automatically generate / clean all other codes (roughly about 30) for that device easily?

Thanks,

miwi