Post 1 made on Monday May 13, 2002 at 21:12 |
build4u Founding Member |
Joined: Posts: | March 2002 84 |
|
|
I have 2 BB835 Speaker Craft amps. I just added a 2nd Elan 630 to the system and found out that one of the amps seems to have a problem with the 12V trigger. The 630 comes on and it switches the amp on. The problem comes in when I turn off the system. The amp stays on. If I remove the 1/8" Mono plug from the 630 the amp turns off. When I plug it back in the amp turns on.
I tried the same 630 with the other amp and all works fine.
I also tried connecting the 630 to the Amp (good One) then the amps trigger to the 2nd amp (bad one). Still the same prob.
Any thoughts MLD
|
|
Post 2 made on Monday May 13, 2002 at 21:55 |
jwalkup Founding Member |
Joined: Posts: | December 2001 320 |
|
|
Make sure you have selected 12v power-on and not the signal sensing power-on. It should turn off either way, but check it anyway.
John
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.