Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
MX4000 code learning not working
This thread has 4 replies. Displaying all posts.
Post 1 made on Thursday February 15, 2024 at 10:29
djarchow
Long Time Member
Joined:
Posts:
July 2006
59
I am trying to get an Amino 7XM cable box programmed into the MX4000. The code set is missing a number of commands so I will have to learn them. When I go into learn mode in CCP, the learn dialog says the status is Learn ready, but it never learns the code from the Amino remote and eventually times out.

I grabbed an MX-850 and tried to learn some commands from that and still no luck.

Has anyone tried learning in the MX4000 editor?

Thanks
Dennis
Post 2 made on Thursday February 15, 2024 at 11:57
DJ Garcia
Founding Member
Joined:
Posts:
August 2001
403
How close is the emitting remote is from the MX-4000? The guide specifies 1-3 inches for learning distance.
DJ - MX-4000 LG 77G3
Post 3 made on Thursday February 15, 2024 at 12:05
DJ Garcia
Founding Member
Joined:
Posts:
August 2001
403
I just tried and it worked, but it's a bit clumsy to set up because you need to aim that close to the front with the connecting cable in place.
DJ - MX-4000 LG 77G3
Post 4 made on Sunday February 25, 2024 at 11:00
tomciara
Loyal Member
Joined:
Posts:
May 2002
7,968
Some of these new cable boxes are Bluetooth remote only.  Donít know about yours.  You could try your phone camera to see if you can see IR being emitted, first with working codes from the 4000 for test, than the Amino (?) remote.
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions.
OP | Post 5 made on Sunday February 25, 2024 at 11:59
djarchow
Long Time Member
Joined:
Posts:
July 2006
59
Tom,

Thanks. It was just the MX4000 needing the other remote much closer to do the learn than I was used to with previous URC remotes.
Dennis


Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse