Post 1 made on Monday June 12, 2023 at 01:42 |
pajr2179 Long Time Member |
Joined: Posts: | March 2013 57 |
|
|
I created a normal and pressed state button for a device using the woodwork button templates. However, the "Pressed state" button appears blue rather than the normal tone of the button. Once downloaded, if I hit the button on my remote a solid blue rectangle appears. Any ideas what I may be doing wrong?
Thanks everyone!
|
Pete |
|
Post 2 made on Monday June 12, 2023 at 08:10 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,299 |
|
|
look in the properties section of the button in CCP. click the button on the simulator screen, then go to the properties tab. you should see both states of the button shown in this tab. it is probably set to inverted. just click on the button next to the color palette icon and it should toggle it.
|
|
|
OP | Post 3 made on Monday June 12, 2023 at 10:19 |
pajr2179 Long Time Member |
Joined: Posts: | March 2013 57 |
|
|
I really appreciate the advice. I will try again tonight. I was up until 2am trying to figure it out and I only succeeded in being aggravated. I know a lot of the members here do this for a living and I appreciate the help.
Pete
|
Pete |
|
OP | Post 4 made on Tuesday June 13, 2023 at 00:06 |
pajr2179 Long Time Member |
Joined: Posts: | March 2013 57 |
|
|
It worked. Thank you so much!
|
Pete |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.