Post 1 made on Wednesday September 21, 2022 at 05:53 |
Andoreaw Junior Member |
Joined: Posts: | September 2022 1 |
|
|
Hello I have an MX3000 remote, and an MSC 400 controller. I am using Residential Complete Control Program as a programming tool. My question is : I need to send a 12V trigger output to my power amps with the MSC400, I can't figure out how to program the rear 12V output/relays on the MSC.... I can't see any option to program them in CCP software.
Is there something I am missing...?
Thank you
Regards,
Andrea
|
Andrea |
|
Post 2 made on Wednesday September 21, 2022 at 14:01 |
Mike Stewart Long Time Member |
Joined: Posts: | March 2003 95 |
|
|
There's a button in the Smart Macro window (second button from the right) to add a relay command.
For more info, check the MSC-400 CCP Programming Manual [under Help/Tech Guides in CCP], starting on p. 33. Relays are mentioned on p. 36.
Good luck!
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.