Post 1 made on Tuesday March 25, 2008 at 08:07 |
Drummond Paul Long Time Member |
Joined: Posts: | October 2007 32 |
|
|
I was trying to download a set up from these forums and the software came up with an error msg and left the remote stuck on loader. I pulled out the batteries and now I've got nothing, only the two permanent horizontal lines. I've tried the listen/enter combo and it's still a dead remote. Anyone have any idea how to fix this, other than return the unit. Thanks
|
|
Post 2 made on Tuesday March 25, 2008 at 12:32 |
Surf Remote Loyal Member |
Joined: Posts: | July 2001 5,958 |
|
|
Are you able to establish any connection to the remote? Under "Communications", check "Firmware Version" to see. If so, have you tried downloading a blank or default 10 device (but empty) configuration to the remote?
Mike
|
www.SurfRemoteControl.comTHX-certified video calibrator and contributing writer, ProjectorReviews.com |
|
OP | Post 3 made on Wednesday March 26, 2008 at 07:51 |
Drummond Paul Long Time Member |
Joined: Posts: | October 2007 32 |
|
|
No, I can't even get my computer to recognise that a device is attached.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.