Odd behavior... Not a big deal remote seems to function fine but...

When I use the wizard to config my activities and I set my RF settings to RF only, when the activity macro runs I get a blue screen on the remote that says its configuring please wait you don't have to point the remote... (I assume this is the RF config screen)

Though when I add custom commands to the activity (to make it actually work right) with the browser. I now get a reg screen when I run the activity that tells me its configuring and I SHOULD point the remote... (I assume this is the IR config screen)

My RF settings are still RF only...

Is this a known bug, expected behavior?

Anyway I can force the blue RF screen?

hmmm well I found a work around...

If I setup my custom codes/buttons in the browser then through the Tuner activity resolution fit them in there by some means. I then can rerun the activity wizard and keep the blue RF splash screen.

Example was discrete inputs, remote was set for discrete but each input was just sending the input menu command rather then going to any input in particular.

I created new buttons under the device and imported discrete commands through hex.

I then used the tuner to associate the listed inputs to the newly created buttons. I am guessing you could create macro buttons and inject them this way too. I then recreated the activity with the wizard instead of directly editing with the browser.

Seems round about way to get this done but oh well...