Your Universal Remote Control Center
RemoteCentral.com
Philips iPronto Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 1 made on Thursday February 19, 2004 at 19:51
Barry Gordon
Founding Member
Joined:
Posts:
August 2001
2,153
I started my ipronto conversion by opening my pronto Pro ccf. It looked good, but I just noticed that the last field (the last off timing burst) of every learned IR entry from the ccf has a value of zero. Now logically this should not matter other than it would theoretically allow two patterns in a macro to be too close together. Has any body had any experience with this. I can hand correct it, but will it matter?


Hosting Services by ipHouse