On 08/26/04 02:34 ET, DWost said...
The third code works the same as the original
one I posted. It didn't work when I give it a
quick press, however, it does work when I hold
it down.
That's the one that begins "0000 006C 0044 0000" ?
That command should not have ANY difference between a quick press and a long press. So I think either I'm misunderstanding you, or you didn't test what you think you tested.
Am I stuck holding down the button or
can you hack it further and add a delay to the
toggle code?
We almost always fail in attempts to get the NG model Prontos to extend signals, especially On/Off signals for projectors.
Maybe there is some sequence of commands that tells the projector to turn On or Off bypassing its need for an extended signal (some have menus with confirm steps).
