On June 11, 2007 at 12:27, RTI Installer said...
I only installed one composite filter on the K4 side,
Then deactivated the light sensor. All the other TV displays
cleared up when I did this, I emagine, you would have
to do this with every K4 that is in the system to correct
the problem. I have not had to put a filter on the component
side of anything yet, but I have been curious If I could
use 3 of these low cost filters in a component video senario?
I dont know if the band width is great enough So I am
going to give that a try as well.
I am curious about that because of other TVs in a system without an inwall of any kind having the rolling lines. I absolutely hate having to go through a rack loaded with distro/theater gear to find a ground loop source....