Your Universal Remote Control Center
Blu-ray & DVD Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 10 made on Thursday November 20, 2008 at 23:15
Long Time Member
November 2004
On October 9, 2008 at 12:11, Crustyloafer said...
Hi all,

I am having a bit of trouble programming a TSU9600 with
the IR codes for a Yamaha BD-S2900 Blu-Ray player.

Yamaha have very kindly send me a document with all the
IR codes on it but I cannot get them to work. The document
they sent me is available from the link below:


For example the disreet 'Power On' is listed as '7C F6'.
now I assume, possibly incorectly, that this translates
to '124 246' in decimal format.

Give the value of these numbers I also assumed that the
codes must be RC6 codes as they are the only ones that
use values that high. I have entered these number as the
system and command number in prontoedit as shown here:

However these codes do not seem to work. Can someone please
point out how to get these to work. Is it possible they
need to be used as RC6A commands, and if so what is the
customer code I need to enter for this product?

Any help you guys can offer would be appreciated.



Easiest way to convert is grab the RAV Edit software from Yamaha.
I also think it might be in the files section here.
You can enter 7C F6 and then see the code that needs to be entered into the Philips software.

I have not done it for awhile, but from memory that is all that is needed to do.

Hosting Services by ipHouse