Hi all,

I am trying to figure out a way to modify a hex code for volume control of a Anthem AVM70 processor but dont know how.

I am programming a URC MX990 remote for it but the volume commands are going way too fast on a press and hold command. Like if you press and hold the volume up button it will blast through from -90 to +10db in a second which makes volume control very difficult to impossible.

This is with the codes from URC in there code database and the hex codes from Anthem.

Trying to learn the codes from the remote only work for a single press. press and hold wont work with the device.

Here is the hex code from Anthem that i was hoping to edit somehow to slow down the rate the volume increases.

0000 006D 0022 0002 0155 00AA 0015 0040 0015 0015 0015 0040 0015 0015 0015 0015 0015 0015 0015 0015 0015 0040 0015 0015 0015 0040 0015 0015 0015 0040 0015 0015 0015 0040 0015 0040 0015 0015 0015 0040 0015 0040 0015 0040 0015 0040 0015 0040 0015 0015 0015 0015 0015 0040 0015 0015 0015 0015 0015 0015 0015 0015 0015 0015 0015 0040 0015 0040 0015 0015 0015 05ED 0155 0055 0015 0E47

And this is the volume down code:

0000 006D 0022 0002 0155 00AA 0015 0040 0015 0015 0015 0040 0015 0015 0015 0015 0015 0015 0015 0015 0015 0040 0015 0015 0015 0040 0015 0015 0015 0040 0015 0015 0015 0040 0015 0040 0015 0015 0015 0015 0015 0040 0015 0040 0015 0040 0015 0040 0015 0015 0015 0015 0015 0040 0015 0040 0015 0015 0015 0015 0015 0015 0015 0015 0015 0040 0015 0040 0015 0015 0015 05ED 0155 0055 0015 0E47

Thanks for any help.
Tim.