Your Universal Remote Control Center
RemoteCentral.com
RS-232 & IP Control Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 99 made on Thursday December 3, 2020 at 08:11
Duct Tape
Loyal Member
Joined:
Posts:
November 2008
5,214
On December 2, 2020 at 20:19, xperttech said...
Experts,

I'm still experiencing issues getting any command through Serial-to-USB as i my Post 94. Today I'm testing on a new Samsung UN65TU8000FXZA. Similar to one I tested before. No luck. I can't believe this is not even working for Power On.

What am I doing wrong?

My settings are the same as above:

//
Service Mode settings: --RS-232 Jack: UART --EXT Link Support: ON --USB Serial: ON Hotel/Hospitality Mode: OFF
Standard settings: --AnyNet+: OFF
EX-Link com port settings: --9600 or 115200 baud --8 bit --no parity --1 stop bit --no hardware flow control

//

Please help!

XT

you tried reversing the Tx and Rx pins on your cable?  That's the first thing I do when things should be working, but are not.
[Link: facebook.com]


Hosting Services by ipHouse