Your Universal Remote Control Center
Philips Pronto NG Family Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 8 made on Monday August 17, 2020 at 09:19
Junior Member
August 2020
Thought it might have been a wireless access point interfering with the signal but that is now out of the way.

I might be wrong but i'm sure i read somewhere that i can check what rf frequency the pronto is set to on the device its self?

Can this be done though the pronto or is it only through the pronto ng software?

Is it a good idea to turn off the blaster if i'm using ir cables?

Hosting Services by ipHouse