Your Universal Remote Control Center
Blu-ray & DVD Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 2 made on Tuesday December 9, 2008 at 03:59
Daniel Tonks
Wrangler of Remotes
October 1998
Just do "HDMI Auto" and leave it at that. I don't think it uses 3/4 of them anyways, but if auto selects them then the receiver should handle them.

However, if you don't have 7.1 then I would unselect all of those - unless you can verify that your receiver will correctly reprocess 7.1 LPCM correctly to 5.1.

Otherwise, if you only allow 5.1 LPCM output and the PS3 plays a 7.1 track, it will correctly route the extra rear channels into the others.

The PS3 will *always* output BD high resolution tracks as LPCM. Make sure you have HDMI set to PCM output and not bitstream, otherwise it'll be reprocessing any uncompressed tracks into compressed.

Hosting Services by ipHouse