On June 13, 2013 at 17:34, highfigh said...
I thought I read or was told about a Safe Mode- IIRC, remove the battery, press and hold the power ON button and re-insert the battery, letting it reboot. Then, do a firmware update while in Safe Mode before removing the battery and re-inserting it normally.
Or, is that just Harmony?
980 has no boot loader/safe mode. many URC remotes do though....
Doesnt excuse the rudeness of the tech guy.
I had a similar issue with a 980 this wek as well. Older unit, just sits there and flashes sometimes. if the bateryis pulled for 30+ minutes, it seems to boot up and run fine for a while.. then reverts back to just flashing....
Was told there was nothing they could do since the unit was out of warranty.