Post 7 made on Tuesday April 24, 2012 at 00:38 |
athomebythebeach Long Time Member |
Joined: Posts: | January 2011 10 |
|
|
Sorry, I misread your first reply as "you'll need to check all three pages" instead of "you'll need to check all the pages", so I did not go far enough through the pages.
Now I have your codes and I entered several of them into my .ncf file with Neohacker.
So far, no success. The RNG150N does not respond.
To be sure I am doing it correctly, I entered the appropriate code into the box at the bottom of the Neohacker page then hit "save parameter" for each button. Then I saved the file and loaded it into the ProntoNeo TSU500. Is this correct?
By the way is there a way to cut and paste the codes in Neohacker?
Sorry to ask such a basic question but this is my first attempt.
|
|
|